I managed to get a six-pin cable from a supplier of hobby robot gear. The orientation of the red stripe matched the graphic in the intellijel documentation so I went with it. Output level is pretty close to line level using the line in gain settings on my tascam usb16 interface, so everything works nicely.Addendum to my last post - I guess the pins don't matter if you can find a ribbon cable with 6-pin IDC sockets on either end - just connect to the shrouded housing on the case and place the red stripe where indicated on the Bartender - assuming the cable is wired correctly.
Statistics: Posted by Jumbuktu — Sun Jun 09, 2024 11:13 pm