Hi everyone, been reading through this thread to try and gain some information on the issues I have with mine. Not sure if any of you are still active on here but if you are and have any insight to my problem, it would be much appreciated.
My poly61 doesn't load up properly. all lights come on except for the Indicator Value Display, unlessss... I twiddle with either the 'from' or 'to tape' switches. If I press either one of them down then it loads up as it should and plays perfectly but I have to keep my finger on the switch or stick it down with tape.
I'm a complete noob when it comes to circuit boards and testing where there might be a fault, if its even the board that is the issue or just a faulty connection somewhere. The board is super clean other than a couple of traces from the battery area have eroded away.
I had it serviced about 2 years ago and they replaced the battery and power supply.
Any info would be amazing.
Best
My poly61 doesn't load up properly. all lights come on except for the Indicator Value Display, unlessss... I twiddle with either the 'from' or 'to tape' switches. If I press either one of them down then it loads up as it should and plays perfectly but I have to keep my finger on the switch or stick it down with tape.
I'm a complete noob when it comes to circuit boards and testing where there might be a fault, if its even the board that is the issue or just a faulty connection somewhere. The board is super clean other than a couple of traces from the battery area have eroded away.
I had it serviced about 2 years ago and they replaced the battery and power supply.
Any info would be amazing.
Best
Statistics: Posted by airforcetone — Fri Nov 08, 2024 5:45 am