This one is pretty cool:
Wear and Tear is great at subtle lo-fi tape effects (warble, hiss, crinckles, etc) as well as heavy sound destruction and mangling. I had a lot of fun using Wear and Tear in the feedback loop of delay modules (like 4ms DLD) and it sounds really good as an end-of chain effect. At the press of a button the “tape stop” feature slows the outcoming signal to a halt, just like turning down the tape speed to 0 on an old cassette player. Press the stop button again and signal ramsp up again with controllable fall and rise times. You can use the “stop” input to sequence this and get some really cool results.
AUDIO EFFECTS
Tape Saturation
Wow & Flutter
Low Pass Filter
High Pass Filter
Noise
Crinkles
Tremolo
Compression
EQ
TECHNICAL SPECIFICATIONS
Width: 16hp
Depth: 30mm
Input: Stereo
Output: Stereo
Sample Rate: 48kHz / 24bit
Power consumption:
+12V: 145 mA
-12V: 8 mA
5V: 0 mA
Here is an overview video from &&:
Wear and Tear is great at subtle lo-fi tape effects (warble, hiss, crinckles, etc) as well as heavy sound destruction and mangling. I had a lot of fun using Wear and Tear in the feedback loop of delay modules (like 4ms DLD) and it sounds really good as an end-of chain effect. At the press of a button the “tape stop” feature slows the outcoming signal to a halt, just like turning down the tape speed to 0 on an old cassette player. Press the stop button again and signal ramsp up again with controllable fall and rise times. You can use the “stop” input to sequence this and get some really cool results.
AUDIO EFFECTS
Tape Saturation
Wow & Flutter
Low Pass Filter
High Pass Filter
Noise
Crinkles
Tremolo
Compression
EQ
TECHNICAL SPECIFICATIONS
Width: 16hp
Depth: 30mm
Input: Stereo
Output: Stereo
Sample Rate: 48kHz / 24bit
Power consumption:
+12V: 145 mA
-12V: 8 mA
5V: 0 mA
Here is an overview video from &&:
Statistics: Posted by Paranormal Patroler — Fri May 10, 2024 2:11 am