HI everyone,
I'm having hard times getting the 1V/oct working.
Did some research here and went through the basics :
1. allowing the 1v/OCT option
2. having the CV attenuator full CW
3. the pitch knob full CCW
When I sequence a C it's a F# out of the QD. I tried different :
- WT, samples on the QD
- sequencers : westlicht performer and a deluge
- VCO's to compare with the QD
It track well the different octaves : C1 is F#1 / C2 is F#2 / ...
I tried to calibrate but when I when I push and hold the encoder, to validate the calibration procedure, I get the state progress with the green LEDs but after that the unit freezes = all led are lit and the unit doesn't respond, I have to turn off/on my case.
I installed the last firmware V1.11.1
Before that firmware the calibration process didn't freeze but I had the same "offset".
Would appreciate some help, thanks
Hi,
I tried several things this morning in this order and tried again the V/OCT + calibration (with ornament&crime app) in between each step :
1. deleting all files on the sd card + formating EXFAT32 + loading all files in one drop
2. reverting to firmware 1.10.7
3. factory reset
4. loading firmware 1.11.1 again
What I get is that :
- the VCO's from the digital modelling (white bank) works fine and in tune with my sequencers : a C (sequencer) is a C (QD)
- all the Wave tables (purple) are not in tune with my sequencer : a C (sequencer) is still a F#
What I learned from my attempts is :
- don't hold the middle encoder until the end of the green led progression when you want to validate the calibration process = it freezes my unit
- same don't hold the 4 led too long when you factory reset the unit = when I hold it too long a continuous tone was outputting by the QD.
@av500 could you please help me?
Statistics: Posted by guitooo — Tue Nov 05, 2024 3:57 am